Hi,
Here is a little joy for your ear, eye, and mind
Design to last forever, with soul.
The LAB blog is where we get nitty-gritty into the technical
LAB Blog
-
Altec 1005B: #5 Mouth Section – Modal Simulation
An initial Mouth Section prototype was built and measured. Felt was added for damping and correlated to modal simulation.
-
Altec 1005B: #4 Mouth Section – Design with FEA
This section will focus on theoretical studies using FEA method to compare deflection stiffness and modal behavior of various mouth section wall designs.
-
Altec 1005B: #3 Detailed Design
We are now able to start designing the entire horn based on the parameters we previously found.
-
Altec 1005B: #2 Reverse Engineering
The first step involves backing out the dimensions of the horn and each cell.
-
Altec 1005B: #1 Introduction & Motivation. Why 3D Print?
This set of posts aim to document the process of designing and building a replica of the Altec 1005B Multicellular Horn.
